#0004Charmander

Before you start

Every part is in the bag and the print supports are already removed — just lay everything out and follow along.

Steps

1. 1

   Attach the tail flame

   Slot the flame onto the tail tip. It presses in; add a drop of super glue if you want it locked on.

2. 2

   Seat the figure

   Place the Charmander figure onto the peg inside the bottom shell so it sits square and snug. A dab of super glue makes it permanent if you like.

3. 3

   Close the ball

   Line up the two shell halves and press them together until the seam clicks shut, then twist slightly to lock the tabs.

4. 4

   Show it off

   Set it on a shelf as-is, or pop it on a Printamals display stand (add one at checkout) to give it pride of place.